charges for warranty service. The Winegard dealer must contact Winegard Tech-
nical Services in advance for pre-approval of the service.Approval of the service is
at the sole discretion of Winegard Company.
STEP 5. Install connectors on downlead and
set 2 cable as shown in Figure 5. Attach
downlead cable to jack on wallplate/amplifier
marked antenna as shown in Figure 4. Attach
cable going to set 2 outlet to jack on power
supply marked SET 2. Attach cable coming
fromcableinputtojackonpowersupplymarked
CABLE.
INSTRUCTIONS
NOTE:Makesuretheantennaisintheoperating
position (up) and pointed at the station desired.
Alternatively, Customer may ship the product prepaid to Winegard Technical Ser-
vices (located at 3111 Kirkwood Street, Burlington, Iowa 52601, Telephone 800-
788-4417). Customer must return the product along with a brief description of the
problem and provide Winegard Technical Services with Customer’s name, ad-
dress, and phone number. Customer must also provide proof of purchase to verify
the product is under warranty. If the product is returned before the expiration of the
warranty period, Winegard Company will (at its option) either repair or replace the
product.
This Limited Warranty does not apply if the product has been damaged, deterio-
rates, malfunctions or fails from: improper installation, misuse, abuse, neglect, ac-
cident, tampering, modificationoftheproductasoriginallymanufacturedbyWinegard
in any manner whatsoever, removing or defacing any serial number, usage not in
accordance with product instructions or acts of nature such as damage caused by
wind, lightning, ice or corrosive environments such as salt spray and acid rain.This
Limited Warranty also does not apply if the product becomes unable to perform its’
intended function in any way as a result of the television signal provider making any
changes in technology or service.
INSTALLING FC-5910
CONNECTORS ON COAX CABLE
1/2" *
1.
Inner Insulation
¼" *
Outer Cover
2.
Center Conductor
3.
FIGURE 5
MODEL RA-7296
Made in U.S.A.
Crimp Here
Step 1: Strip outer cover back 1/2"* from end of cable. Fray
braid back as far as outer cover will allow.
Set 2
Step 2: Trim braid close to outer cover and remove 1/4"* of
inner insulation being careful not to nick center conductor.
Make sure no foil or braid can touch center conductor.
RV WALL PLATE/
AMPLIFIER
RETURN AUTHORIZATION POLICY
AReturn MaterialAuthorization (RMA) is required prior to returning any product to
Winegard Company or Winegard Warranty Services under this warranty policy.
Please call our Technical Services Department at 800-788-4417 or send an e-mail
purchase when requesting an RMA number. Enclose the product in a prepaid
package and write the RMA number in large, clear letters on the outside of the
package. To avoid confusion or misunderstanding, a shipment(s) without an RMA
number(s) or an unauthorized return(s) will be refused and returned to Customer
freight collect.
WINEGARD COMPANY DOES NOT ASSUME ANY LIABILITIES FOR ANY
OTHER WARRANTIES, EXPRESS OR IMPLIED, MADE BYANYOTHER PER-
SON.
ALL OTHER WARRANTIES WHETHER EXPRESS, IMPLIED OR STATUTO-
RY INCLUDING WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE
AND MERCHANTABILITYARE LIMITEDTOTHETWOYEAR PERIOD OFTHIS
WARRANTY.
Step 3: Slide connector tip between braid and inner insulation
(braidandfoil, onfoilshieldcable)andpushconnectoroncable
as far as it will go. Crimp built-in ferrule with proper crimping
tool. Hex connector requires hex crimping tool. Do Not
crush cable out-of-round.
Antenna
DESCRIPTION
FIGURE 4
Cable
Wall plate/amplifier amplifies VHF/UHF TV
signals received by non-amplified Winegard
RV antennas with outdoor receptacle for TV set
and cable input. Wall plate/amplifier provides
a+12Voltreceptacleaswellasantennasignals
to two TV sets. Cable input from outdoor
receptacle connects to wall plate and may be
switched so either antenna or cable signals
may be watched. See applications. Available
in white only.
* If installing in very hot weather, increase dimensions 1/8"
STEP 6. Mount wall plate/amplifier in wall
with screws provided and attach TV set cable to
jack on front. Connect TV set cable to input jack
on TV. Press switch on front of outlet and check
that light is on.
WINEGARD MOBILE PRODUCTS LIMITED WARRANTY
(2 YEARS PARTS; 1 YEAR LABOR)
Winegard Company warrants this product against defects in materials or
workmanship for a period of two (2) years from the date of original purchase. During
year one (1) of such warranty, Winegard Company will also pay authorized labor
costs to an authorized Winegard dealer to repair or replace defective products. No
warranty claim will be honored unless at the time the claim is made, Customer
presents proof of purchase to an authorized Winegard dealer (to locate the nearest
authorized Winegard dealer, contact Winegard Company, 3000 Kirkwood Street,
Burlington, Iowa 52601, Telephone 800-288-8094 or visit www.winegard.com).
CustomermustprovideproofofpurchasewithadatedsalesreceiptfortheWinegard
product to verify the product is under warranty. If the date of purchase cannot be
verified, the warranty period shall be considered to begin thirty (30) days after the
date of manufacture.
If a defect in material or workmanship is discovered, Customer may take the
product to an authorized Winegard dealer for service. Customer must provide
proof of purchase to verify the product is under warranty. If the product is brought to
an authorized Winegard dealer for service prior to expiration of year one (1) of the
warranty period and a defect in material or workmanship is verified by Winegard
Technical Services, Winegard Company will cover the Winegard dealer’s labor
In states that do not allow limitations on implied warranties, or the exclusion of
limitation of incidental or consequential damages, the above limitations or exclu-
sions do not apply.
Some states do not allow limitations on how long an implied warranty lasts, or the
exclusion of limitation of incidental or consequential damages, so the above limita-
tions or exclusions may not apply to you.
OPERATION: To receive cable signals
from outdoor receptacle: Press switch to
OFF position. Light on wallplate will go (OFF)
showing that power is no longer connected to
theamplifierandthatbothTVsetsarereceiving
signals from outdoor receptacle.
This warranty gives Customer specific legal rights. Customer may also have oth-
er rights that may vary from state to state.
NOTE: THIS UNIT IS AN AMPLIFIER. USE ONLY
WITH NON-AMPLIFIED RV ANTENNAS.
SATELLITE RECEIVER WARRANTY
See manufacturer’s limited warranty policy.
WS-MOBWARREV2Rev.1/10
To receive signals from antenna: Press
switch to ON position. Light on wallplate will
come (ON) showing that power is connected to
the amplifier and both TV sets are receiving
signals from the antenna.
WINEGARDCOMPANY
3000 KIRKWOOD ST., BURLINGTON, IA 52601-2000
Printed in U.S.A. 2451489 Rev. 1/10
|