Winegard Satellite TV System RD 9046 User Manual

®
WINEGARD  
46 cm Portable Satellite System  
Models RD-9046/RD-9146  
Antenna Reflector at 90°  
ANTENNA/MOUNT  
MADE IN U.S.A.  
U.S. Patents 5,532,710  
24° look angle  
& 5,646,638  
UNPACKING/ASSEMBLY  
After unpacking the system, verify that you have a level,  
compass (attached to base), and 25 feet of coax. If you  
do not, call Winegard Company at 1-800-288-8094  
between the hours of 8:00 a.m. and 4:00 p.m. central  
time, Monday through Friday.  
SAVE THE CARTON. This carton is designed to be  
reused to store your system in when not in use.  
OPERATION  
NOTE: Disregard the compass markings, the red  
compass needle always points North. Rotate the  
base so that the other end of the needle points at the  
correctheading(direction)ontheantennabase. DO  
NOT USE THE DEGREE MARKINGS ON THE  
COMPASS.  
STEP 1. Connect coax from LNBF to receiver. If  
additionalcablelengthisrequired, useahighgradeRG-  
6/U type foam cable suitable for satellite signal and an  
FS-8100 cable splice.  
STEP 2. Plug in the receiver and TV.  
STEP 3. Turn TV and receiver ON.  
NOTE: If you have the unit sitting on a tailgate or on  
othermetalitems,itisrecommendedthatyouremove  
thecompassfromthebaseandstandaway(15'min.)  
to find the correct azimuth. Compass is attached to  
base with velcro.  
STEP 4. Tune TV to ch. 3 or 4 (to the same channel as  
the output on the receiver.)  
STEP 5. Determine azimuth (direction) and elevation  
required for your position. Refer to receiver manual.  
STEP 9. Adjust azimuth (direction) and elevation (up/  
down) for strongest signal.  
STEP 6. Loosen clamp knobs. Elevate reflector to the  
correct elevation. Align degree of elevation required  
with front of the slide bracket. Each mark indicates 5  
degrees of elevation with the first mark being 00 (mark  
closesttocompass/level). SeeFigures1and2. Tighten  
clamp knobs.  
NOTE: Ifyoudonotgetapicture,checkthefollowing:  
1. Make sure antenna has clear view of the high  
power satellites, no buildings, trees, etc.  
blocking the view.  
2. Make sure coax connections are good.  
3. Check coax for breaks, crimps, cuts etc.  
4. If base is not level, you will have to adjust the  
elevationtocompensate.  
STEP 7. Level base using bubble level recessed into  
the base.  
5. Check that TV is tuned to correct channel.  
STEP 8. Usingcompassrecessedintobase,rotatethe  
base slowly (3o increments) to the desired azimuth  
(direction) for the high power satellites. The signal is  
digital, you must wait a few seconds after each move to  
allow the receiver to process the signal.  
CAUTION: DONOTDROPSYSTEM. IFANTENNAIS  
DAMAGED,ITWILLREDUCETHEGAIN(HOWMUCH  
SIGNAL THE ANTENNA SENDS TO THE RECEIVER)  
OF THE ANTENNA. THIS CAN RESULT IN A  
DEGRADED PICTURE.  
 
How To Hook A Satellite System To A RV Cable Input  
Satellite Receiver  
RD-9046 Portable  
Satellite System  
WINEGARD MOBILE PRODUCTS LIMITED WARRANTY  
(2 YEARS PARTS; 1 YEAR LABOR)  
Winegard Company warrants this product against defects in materials or workmanship for a period of two (2) years from the date of original purchase. During year one (1) of such  
warranty, Winegard Company will also pay authorized labor costs to an authorized Winegard dealer to repair or replace defective products. No warranty claim will be honored unless at  
the time the claim is made, Customer presents proof of purchase to an authorized Winegard dealer (to locate the nearest authorized Winegard dealer, contact Winegard Company, 3000  
product to verify the product is under warranty. If the date of purchase cannot be verified, the warranty period shall be considered to begin thirty (30) days after the date of manufacture.  
If a defect in material or workmanship is discovered, Customer may take the product to an authorized Winegard dealer for service. Customer must provide proof of purchase to verify  
the product is under warranty. If the product is brought to an authorized Winegard dealer for service prior to expiration of year one (1) of the warranty period and a defect in material or  
workmanship is verified by Winegard Technical Services, Winegard Company will cover the Winegard dealer’s labor charges for warranty service. The Winegard dealer must contact  
Winegard Technical Services in advance for pre-approval of the service. Approval of the service is at the sole discretion of Winegard Company.  
Alternatively, Customer may ship the product prepaid to Winegard Technical Services (located at 3111 Kirkwood Street, Burlington, Iowa 52601, Telephone 800-788-4417). Customer  
must return the product along with a brief description of the problem and provide Winegard Technical Services with Customer’s name, address, and phone number. Customer must also  
provide proof of purchase to verify the product is under warranty. If the product is returned before the expiration of the warranty period, Winegard Company will (at its option) either repair  
or replace the product.  
This Limited Warranty does not apply if the product has been damaged, deteriorates, malfunctions or fails from: improper installation, misuse, abuse, neglect, accident, tampering,  
modification of the product as originally manufactured by Winegard in any manner whatsoever, removing or defacing any serial number, usage not in accordance with product instructions or  
acts of nature such as damage caused by wind, lightning, ice or corrosive environments such as salt spray and acid rain. This Limited Warranty also does not apply if the product becomes  
unable to perform its' intended function in any way as a result of the television signal provider making changes in technology or service.  
RETURNAUTHORIZATION POLICY  
A Return MaterialAuthorization (RMA) is required prior to returning any product to Winegard Company or Winegard Warranty Services under this warranty policy. Please call our Technical  
Services Department at 800-788-4417 or send an e-mail to [email protected] to obtain the RMA number. Please furnish the date of purchase when requesting an RMA number. Enclose  
the product in a prepaid package and write the RMAnumber in large, clear letters on the outside of the package. To avoid confusion or misunderstanding, a shipment(s) without an RMAnumber(s)  
or an unauthorized return(s) will be refused and returned to Customer freight collect.  
WINEGARD COMPANY DOES NOT ASSUME ANY LIABILITIES FOR ANY OTHER WARRANTIES, EXPRESS OR IMPLIED, MADE BY ANY OTHER PERSON.  
ALL OTHER WARRANTIES WHETHER EXPRESS, IMPLIED OR STATUTORY INCLUDING WARRANTIES OF FITNESS FOR APARTICULAR PURPOSEAND MERCHANTABILITY  
ARE LIMITED TO THE TWO YEAR PERIOD OF THIS WARRANTY.  
In states that do not allow limitations on implied warranties, or the exclusion of limitation of incidental or consequential damages, the above limitations or exclusions do not apply.  
Some states do not allow limitations on how long an implied warranty lasts, or the exclusion of limitation of incidental or consequential damages, so the above limitations or exclusions  
may not apply to you.  
This warranty gives Customer specific legal rights. Customer may also have other rights that may vary from state to state.  
WS-MOBWARREV2  
SATELLITE RECEIVER WARRANTY:  
See manufacturer’s limited warranty policy.  
Rev.1/10  
 
ANTENNA EXPLODED PARTS VIEW  
Below is the exploded parts view for the 46 cm portable  
satellite system. If you require a replacement part, call  
RECEIVER WARRANTY  
Receiver is warranted by the manufacturer. See  
instructionmanualpackedwithreceiverforwarranty  
information. DO NOT SEND receiver to Winegard  
Company; it will be returned you. Only Echostar  
receivers will be accepted and ONLY from dealers.  
Winegard Company at 1-800-288-8094 between the  
hours of 8:00 a.m. and 4:00 p.m central time, Monday  
through Friday. Credit card orders only.  
2745307  
46 cm Reflector  
(4) 2160361  
5/16-18x5/8"FlatHeadBolt  
2753065  
25' Coax  
2160353  
(4) 2160230  
5/16-18 Hex Nut  
1/4-20 X 1.25 LONG  
CARRIAGE BOLT  
2744846  
FEED SUPPORT  
ARM  
2200921  
Reflector Bracket  
2780190  
LNBF  
(5) 2160027  
5/16" Washer  
2160821  
Spring (not shown)  
(2) 2745048  
Pivot Link  
(4) 2160690  
0.312 x 0.660  
Round Head Pin  
2160220  
1/4-20  
HEX NYLOCK NUT  
(2) 2240021  
Rubber Bumper  
(2) 2200096  
Clamp Knob  
2200816  
Base  
2160691  
0.312 x 2.91  
Round Head Pin  
2160692  
0.312 x 3.36  
Round Head Pin  
(6) 2160696  
E-Clip Retainer  
3201818  
Slide W/Inserts  
2780257  
Compass  
2780258  
Level  
Rev. 1/10  
Printed in U.S.A. Winegard Company, 3000 Kirkwood St., Burlington, IA 52601-2000 800.288.8094 FAX 319.754.0787 © Winegard Company 2006 2451148 Rev 1/10  
 

Whirlpool Freezer RT12FC User Manual
Whirlpool Washer 3953964 User Manual
White Rodgers Home Theater Server 47D43 811 User Manual
Wolf Cooktop M15 S User Manual
Xtant Stereo Amplifier Model X1001 User Manual
Yamaha CD Player CDR1000 User Manual
Yamaha Stereo Receiver HTR 5940 User Manual
Zanussi Refrigerator ZU 9154 User Manual
Zanussi Washer ZWF 1311 W User Manual
Zipper Mowers Automobile Parts 309 365 User Manual