DIRECTV® Receiver Setup for SK-3003
The following instructions assume that the TRAV’LER® antenna has found and locked onto satellites 101°,
110° and 119°. There should be an asterisk next to 101°, 110°, and 119° on the TRAV’LER interface.
In most DIRECTV receivers, the setup is done through the “Repeat Satellite Setup” option in your receiver
menu. The following instructions are based upon an H24 receiver. If your receiver differs from the options
shown, you may need to consult your receiver manual. The wording and display used in your receiver
may differ slightly.
For Help, Call 1-800-788-4417
Press Menu on
your remote,
and then select
Parental, Fav’s &
Setup.
Select System Setup.
1
3
5
2
In your receiver
Menu, you will
need to identify
the Satellite
Menu. The
Satellite Menu
will have an
You may be
required to press
the DASH (-)
before proceeding
(underneath #7 on
the remote).
4
option for
Satellite Setup.
Set Dish Type
for 02: 3-LNB
(18”x20”).
Your installation
will be verified.
6
Set the Switch
Type for
02: Multiswitch.
Press Continue.
Errors may be
Select Continue.
7
8
displayed on the
Installation Status
screen. This is
normal to see one
or two boxes with
an X instead of a .
Select Continue.
|